AT&T Telephone 1070 User Manual

3.0

Out of 11 Ratings

Owner's of the AT&T Telephone 1070 gave it a score of 3.0 out of 5. Here's how the scores stacked up:

  • Reliability

    3.09 out of 5

  • Durability

    2.91 out of 5

  • Maintenance

    3.09 out of 5

  • Performance

    2.91 out of 5

  • Ease of Use

    2.91 out of 5
of 104
 
95
• Make sure that there is an auto attendant
telephone. (See the AUTO ATT SETUP section on
page 46 of this manual.)
• Make sure the answering system answer delay
time (see the ANSWER DELAY section on page 58
of this manual) of all 1080 telephones in the same
system are longer than the auto attendant answer
delay time (see the AUTO ATT DELAY section on
page 49 of this manual).
• If you subscribe to the Centrex service provided
by your local telephone company, make sure the
CSL DELAY RING time (see the CSL DELAY RING
section on page 75 of this manual) is longer than
the AUTO ATT DELAY (see the AUTO ATT DELAY
section on page 49 of this manual) and ANSWER
DELAY time (see the ANSWER DELAY section on
page 58 of this manual) on all system telephones.
• Only the calls from the public lines (shared lines
of all system phones) can be answered by the
auto attendant system (see the Auto attendant
operation section on the 1080 user’s manual).
• If all auto-attendant extensions are being used,
the system cannot answer incoming calls.
The auto attendant does
not answer after the
correct number of rings
(1080 only).
Troubleshooting
• If HEADSET is selected in the AUTOMATIC
MODE menu and a headset is connected on the
telephone, you need to use the headset to hear
messages (page 39).
• Press
[ VOLUME] on the telephone base to
increase the volume.
The messages on the
system are very difficult
to hear (1080 only).
• Make sure you are using the correct remote access
code (see the REMOTE CODE section on page 59
of this manual).
• Make sure you are calling from a touch-tone
telephone (away from home or office). When
dialing a number, you should hear tones. If you
hear clicks, then it is not a touch-tone telephone
and cannot activate the answering system.
• The answering system may not detect the remote
access code when your announcement is playing.
Wait until the announcement is over before
entering the code.
• There may be interference on the telephone line
you are using. Press the dial pad keys firmly when
dialing.
The answering system
does not respond
to remote access
commands.

   Find Your Products By Category