Bushnell Hunting Equipment Bushnell Hunting Equipment User Manual

0

Out of 0 Ratings

Owner's of the Bushnell Hunting Equipment Bushnell Hunting Equipment gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 32
 
6
Lens Covers
In order to preclude the loss of the lens covers when removed from the
optical path of the Sight, the lens covers should be removed downwards.
The rubber string will then grab around the Sight and Base.
Zeroing
The TRS-25 is delivered with the red dot in a centered position. Normally this
means that only small adjustments are necessary, providing that the weapon
rail (Picatinny/Weaver Rail) is properly aligned.
CAUTION: Do not continue to adjust windage and elevation mechanisms if
you encounter resistance.
The Elevation Adjustment Screw is located on top of the sight, while the
Windage Adjustment Screw is located on the right side.
1. Open (remove) Lens Covers .
2. Turn the Switch Knob (B) clockwise until the red dot has a sucient
intensity to contrast against the target.
3. Remove the Adjustment Cap (C) for windage and elevation
adjustment, one at a time.
4. Conrm zeroing by ring at least three shots at a zeroing target. Check
points of impact on zeroing target to conrm accuracy and repeat
above procedure if required.
5. After initial ring, ensure that the sight is secure.
6. Turn Rotary Switch to OFF position (counter clockwise).
7. Close front and rear Lens Covers.
OPERATION UNDER EXTREME CONDITIONS
 Extreme heat (moist or dry): No special procedures required.
 Extreme cold: Extreme cold might shorten battery life. It could
also make the Rotary Switch a little harder to turn than at normal
temperatures.
 Salt air: No special procedures required.
• Sea spray, water, mud and snow: Ensure that Battery Cap and the two
Adjustment Caps are tightened before exposing the Sight to sea spray,
mud, snow or before immersing the sight in water. Hand tighten only.
Keep Lens Covers closed when sight is not being used. Clean lenses
with lens paper/cloth and wipe the sight dry as soon as possible after
exposure to water, sea spray, mud or snow.

   Find Your Products By Category