Broan Ventilation Hood ELITE User Manual

0

Out of 0 Ratings

Owner's of the Broan Ventilation Hood ELITE gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 28
 
MODELS EW5630SS • EW5636SS
Page 6
4. Remove (3) screws holding electronics mounting bracket to
hood. Rotate bracket 180 degrees and re-attach bracket to
hood with same (3) screws.
5. Remove the grease filter by pulling down the metal latch tab
and tilting filter downward to remove.
6. Remove the protective plastic film covering the decorative
flue and the hood at this time.
7. Remove the grease filter by pulling down the metal latch tab
and tilting filters downward to remove.
8. Align the keyhole slots on the hood with the mounting screws
that were partially tightened into the wall framing. Ensure that
hood is seated entirely on mounting screws and that hood is
level. Then tighten screws completely.
9. Install (2) 4mm x 38mm long screws into the holes inside the
hood and tighten them securely.
10. Carefully place glass canopy on top of the hood. Align nuts
on glass canopy with holes inside the hood. Attach canopy
with (4) .188” x .250” long flat head screws. Tighten screws
securely but DO NOT OVERTIGHTEN.
11. Attach filter tray to bottom of hood using (4) .188” x .375”
mounting screws.
12. Snap in 2-non-duct filters into filter trays by engaging filter
tab on side, rotating upward to engage filter clips.
13. Reinstall grease filter by aligning rear filter tab with slots
in the hood. Pull down the metal latch tab, push filter into
position and release. Make sure filter is securely engaged
after installation.

   Find Your Products By Category