Dual GPS Receiver XDVDN9131 User Manual

4.5

Out of 2 Ratings

Owner's of the Dual GPS Receiver XDVDN9131 gave it a score of 4.5 out of 5. Here's how the scores stacked up:

  • Reliability

    4.5 out of 5

  • Durability

    4.0 out of 5

  • Maintenance

    4.5 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    4.5 out of 5
of 84
 
XDVDN9131 OPERATION
32
DVD Setup - Parking Brake Initialization
Front Monitor Video
Initialization
Parking Brake Initialization
Situation 1
Parking Brake Initialization
Situation 2
SAFETY WARNING
• The video display of the in-dash unit will not operate while the vehicle is
moving. This is a safety feature to prevent driver distraction. In-dash video
functions will only operate when vehicle is in Park and the PARKING BRAKE
is engaged. It is illegal in most states for the driver to view video while the
vehicle is in motion. Refer to local laws in your area.
• The vehicle must be in park and the parking brake applied to view video on the
in-dash monitor.
• As a safety feature, !!Safety Warning!! blue screen will show on the display
when the vehicle's parking brake is not engaged. Video display on the front
monitor isn't allowed until the PARKING BRAKE is engaged. Connect the
yellow/blue PARKING BRAKE wire to the brake switch circuit as described
on page 6. Note: DVD and AUX AV audio can be heard while the vehicle is in
motion without engaging the parking brake.
Follow these two initialization procedures carefully to allow video playback on
on the XDVDN9131 front monitor:
There are two situations to initiate the PARKING BRAKE sequence.
First situation (if vehicle is moving):
1) Stop vehicle, put in Park, make sure PARKING BRAKE is off/released.
2) Depress PARKING BRAKE for 1 second.
3) Release PARKING BRAKE for 1 second.
4) Depress PARKING BRAKE permanently.
Note:
Once above procedure 1-4 is completed, video will display in about 2 seconds.
Second situation (if vehicle is already parked and the PARKING BRAKE is
already applied):
1) Keep vehicle in Park, PARKING BRAKE should be on.
2) Release PARKING BRAKE for 1 second.
3) Depress PARKING BRAKE for 1 second.
4) Release PARKING BRAKE for 1 second.
5) Depress PARKING BRAKE permanently.
Notes:
Once above procedure 1-5 is completed, video will display in about 2 seconds.
The transition time must be less than 2 seconds between depress and release.
This procedure must be repeated anytime the vehicle ignition is turned off.
CAUTION !!!
IT'S UNLAWFUL TO OPERATE
A VEHICLE WHILE VIDEO IS
DISPLAY IN THE DRIVERS
VIEWING AREA
ENGAGE EMERGENCY BRAKE
TO WATCH VIDEO

   Find Your Products By Category