0

Out of 0 Ratings

Owner's of the Broan Ventilation Hood EI5936SS gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 32
 
MODEL EI5936SS
Page 5
NON-DUCT KIT MODEL RKE59 CONTENTS
FLEXIBLE DUCT
NON-DUCTED RECIRCULATION FILTERS
NON-DUCT PLENUM
ASSEMBLY
4 MOUNTING
SCREWS
(.188” x .375”
Cross Recessed
Flat Head)
FILTER TRAY
4 MOUNTING
SCREWS
(3mm x 10mm
Cross Recessed
Pan Head)
4 FOAM
RECTANGLES
NOTE
Non-ducted installations require Non-Duct Kit, Model RKE59
(purchase separately).
INSTALL THE HOOD (Non-Ducted Hoods Only - Steps 3 thru 8)
3. Disassemble the frame by removing (8) screws. Set aside
screws and lower frame assembly.
4. Align upper frame assembly to ceiling framing, and attach
to ceiling framing with (6) 4mm x 50mm screws. Tighten
securely, making sure that the upper frame bracket is tight
against the ceiling.
FRONT
CEILING
MATERIAL
IS INSTALLED.
CEILING
FRAMING
ABOVE -
SHOWN
AS DOTTED
LINES.
5. Install non-duct plenum to upper frame bracket using (4)
3mm x 10mm screws.
6. Feed house wiring around front of non-duct plenum.
FRONT
7. Determine length “L” of frame assembly based upon desired
installation height. See chart on page 4. Slide lower frame
over upper frame and attach with (8) screws previously set
aside.
LENGTH
“L”
FRONT