INSTEON Musical Toy Instrument INSTEON Musical Toy Instrument User Manual

0

Out of 0 Ratings

Owner's of the INSTEON Musical Toy Instrument INSTEON Musical Toy Instrument gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 24
 
Page 14 of 24 Rev: 7/25/2013 9:16 AM
2) Press and hold Keypad’s Set button until it beeps.
Set button LED will blink green
3) Send the desired X10 Address plus ON 3 times in a row (e.g. send B5-BON-B5-BON-B5-BON)
Keypad will double-beep and the Set button LED will stop blinking
Remove X10 Address from a Button
If you are no longer going to utilize an X10 address associated with Keypad, it is very important that you remove its
X10 address. Otherwise, Keypad will still listen for X10 commands (somewhat hindering INSTEON reception) and
may respond to spurious X10 “noise” which is unavoidable. Furthermore, Keypad will transmit an X10 address and
command every time the button is pressed.
1) Tap the Keypad button
2) Press and hold Keypad’s Set button until it beeps
Set button LED will blink green
3) Press and hold Keypad’s Set button again until it beeps again
The button’s LED will continue blinking red.
4) Send the X10 Address plus ON 3 times (e.g. send B5-BON-B5-BON-B5-BON)
Keypad will double-beep and the Set button LED will stop blinking
Advanced X10 Programming
Instructions on setting X10 primary address and scene addresses can be found online:
http://www.insteon.com/insteon-x10-programming.html
Power Restore
Keypad stores all of its scenes, properties, etc. in non-volatile memory. As such, all settings are retained after a power
outage. Upon power being restored, Keypad will return its connected load and all LEDs to their states prior to power
outage.
Factory Reset
Factory Reset clears all user settings from Keypad including INSTEON scenes, on-levels, ramp rates, X10
addresses, etc.
1) With a small screwdriver or your fingernail, pull out Set button to create an air gap
2) Wait 10 seconds
3) Push in Set button and hold. Do not let go
Keypad will begin to emit a long beep
4) When the beep stops, release the Set button.
Device’s embedded software will rewrite all settings to factory defaults
A couple of seconds will pass
Keypad will double-beep and its LEDs will return to normal brightness
The connected load will turn on and Keypad will return to ready mode

   Find Your Products By Category