INSTEON Musical Toy Instrument INSTEON Musical Toy Instrument User Manual

0

Out of 0 Ratings

Owner's of the INSTEON Musical Toy Instrument INSTEON Musical Toy Instrument gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 24
 
Page 9 of 24 Rev: 7/25/2013 9:16 AM
INSTEON Setup
A scene consists of 1 or more INSTEON devices that respond to 1 or more INSTEON controller(s). When the
scene is activated (turned on), all scene members return to the states they were at when the scene was
programmed. INSTEON scenes let you activate dramatic lighting moods at the touch of a button. For example, you
can set all the lights in a scene to dim to 50% or turn certain lights on while turning others off, all with the tap of a
button on any INSTEON controller. INSTEON scenes are easy to set up: just follow the directions below.
Add Keypad Button to a Scene as a Controller
Follow the steps below to control a scene (one or more INSTEON devices) from a Keypad button
1) Tap the Keypad button of choice (use ON for 6-button Keypads for “main” scene)
2) Press and hold Keypad’s Set button until Keypad beeps
Keypad’s scene button LED will blink and the Set button LED will blink green
3) Adjust the scene responder to the state you want when the scene is activated from Keypad (e.g., 50%, 25%,
off)
4) Press and hold the responder’s Set button until it double-beeps (or until its LED/load flashes)
Keypad will double-beep and its scene button and Set button LEDs will stop blinking
9
Responder’s LED will stop blinking and it may double-beep
10
5) Confirm that scene addition was successful by tapping on/off on the Keypad scene button
The responder will toggle between the scene’s on level and off
6) If you wish to add more responders to the scene, repeat steps 1-5 for each additional scene responder (or see
Add Multiple Responders to a Scene
)
Remove Keypad Button from a Scene as a Controller
If you are disabling (or removing) any scene responders of Keypad, it is very important that you remove it from the
Keypad scene before disabling if at all possible. Otherwise, delays and error blinks / reports may result. If the
device is not available to disable using this technique please use software to remove it from Keypad.
1) Tap the Keypad scene button (ON for 6-button main scene)
The responder(s) will respond
2) Press and hold the Keypad’s Set button until it beeps
Keypad’s scene button LED will blink and the Set button LED will blink green
3) Press and hold the Keypad’s Set button until it beeps again
Keypad’s scene button LED will continue blinking and Set button LED will blink red
4) Press and hold the responder’s Set button until it double-beeps and/or LED blinks
Keypad will double-beep and its scene button and Set button LEDs will stop blinking
5) Confirm that Unlinking was successful by tapping the scene button on and off.
The responder will not respond
6) If you wish to remove multiple responders from Keypad, repeat steps 1-5 for each additional responder (or see
Remove Multiple Responders from a Scene
)
9
If either the Keypad or responders LED continues to blink, the addition failed. Tap the device’s Set button until LED stops blinking and try again.
10
If either the Keypad or responders LED continues to blink, the addition failed. Tap the device’s Set button until LED stops blinking and try again.

   Find Your Products By Category