INSTEON Musical Toy Instrument INSTEON Musical Toy Instrument User Manual

0

Out of 0 Ratings

Owner's of the INSTEON Musical Toy Instrument INSTEON Musical Toy Instrument gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 24
 
Page 4 of 24 Rev: 7/25/2013 9:16 AM
Before Installation
CAUTIONS AND WARNINGS
Read and understand these instructions before installing and retain them for future reference.
This product is intended for installation in accordance with the National Electrical Code and local regulations in the United States or the
Canadian Electrical Code and local regulations in Canada. Use indoors only. This product is not designed or approved for use on power lines
other than 100VAC- 277VAC 50/60Hz, single phase. Attempting to use this product on non-approved power lines may have hazardous
consequences.
- Use only indoors or in an outdoor rated box
- Be sure that you have turned off the circuit breaker or removed the fuse for the circuit you are installing this product into. Installing this
product with the power on will expose you to dangerous voltages.
- The wires connecting Keypad to the incoming power must be protected by a fuse or circuit breaker of 20A or less.
- Connect using only copper or copper-clad wire
- This product may feel warm during operation. The amount of heat generated is within approved limits and poses no hazards. To
minimize heat buildup, ensure the area surrounding the rear of this product is as clear of clutter as possible.
- Each INSTEON product is assigned a unique INSTEON ID, which is printed on the product’s label.
- To reduce the risk of overheating and possible damage to other equipment, do not use this product to control loads in excess of the
specified maximum(s) or install in locations with electricity specifications which are outside of the product’s specifications. If this device
supports dimming, please note that dimming an inductive load, such as a fan or transformer, could cause damage to the dimmer, the
load bearing device, or both. If the manufacturer of the load device does not recommend dimming, use a non-dimming INSTEON on/off
switch. USER ASSUMES ALL RISKS ASSOCIATED WITH DIMMING AN INDUCTIVE LOAD.
- When mounting multiple-ganged junction box, the Keypad Dimmer is de-rated for 200-watts less for each immediately adjacent dimmer
installed. For example, 600 W load control becomes 400 W with another dimmer to the immediate right or left. Use a triple-gang box
with a mechanical switch in the center to avoid de-rating.
IMPORTANT!
If you have any difficulties or questions, consult an electrician. If you are not knowledgeable about or and comfortable with electrical circuitry,
you should have a qualified electrician install the product for you.
In the Box
Tools Needed
Optional Accessories
Keypad Dimmer Module
Flathead screwdriver
Wire cutter/stripper
Mini Remote
Quick Start Guide
Phillips screwdriver
Voltage tester
INSTEON Hub
Button Naming
Throughout this manual, we will use the following naming conventions:

   Find Your Products By Category