0

Out of 0 Ratings

Owner's of the INSTEON Thermostat INSTEON Thermostat gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 28
 
Page 20 of 28 Rev: 1/21/2014 8:35 AM
o Sub-mode 03: Humidity high setpoint (default is 90%)
o Sub-mode 04: Temperature format select (default is Fahrenheit)
o Sub-mode 05: Beep on button press (default is Off)
o Sub-mode 06: Status LED (default is Off)
o Sub-mode 07: Button lock (default is Off)
o Sub-mode 08: Programming lock (default is Off)
o Sub-mode 09: Activation delay (default is 5 minutes)
Press the Up or Down arrow to change a setting.
Sub-mode 01: LED backlight ON time (10second default)
a. Tap Up or Down arrow to step between Off, 10 sec, 60 sec and On
b. Use HouseLinc software to set the LED backlight ON-time in 1-second intervals
Sub-mode 02: Humidity low setpoint (humidification, 30% default)
a. Up arrow = Increase humidity % setpoint
b. Down arrow = Decrease humidity % setpoint
c. Range = 0 to 79%
Sub-mode 03: Humidity high setpoint (dehumidification, 90% default)
a. Up arrow = Increase humidity % setpoint
b. Down arrow = Decrease humidity % setpoint
c. Range = 20 to 90%
Sub- mode 04: Temperature format select (C or F, F default)
a. Up arrow = C
b. Down arrow = F
Sub-mode 05: Beep on button press (enable/disable, OFF default)
a. Up arrow = ON
b. Down arrow = OFF
Sub- mode 06: Status LED (enable/disable, OFF default)
a. Up arrow = ON
b. Down arrow = OFF